A professional chimney sweep in Lawrence is the fastest way to cut creosote buildup, stop smoke backdraft, and keep your wood stove running hot. We serve homeowners across Marion County with CSIA Certified Chimney Sweep technicians, HEPA vacuums, and inspection cameras. Fall is booking season here, so if you have not had the flue cleaned since last winter, now is the time to get on the schedule.
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now (855) 959-5820 → No spam. No obligation. Just practical help.
A professional chimney sweep in Lawrence is not just a brush on a rod. We run a chimney brush and chimney rods through the flue, break loose glazed creosote, then pull the soot out with a HEPA vacuum so nothing lands on your carpet. An inspection camera goes up the flue to check flue tiles, mortar joints, and the chimney crown for cracks. If the liner is failing, we tell you before it becomes a $6,000 rebuild.
Lawrence homes take a beating from our weather. Freeze-thaw cycles crack mortar and firebrick, and long damp springs let creosote sit and harden into a glaze that a standard brush will not touch. That is why a certified chimney sweep Lawrence homeowners call in October usually finds stage-two or stage-three creosote. We also clear animal nests, fix chimney leaks around the cap, and check that your chimney cap tool and stainless steel liners are still doing their job.
Every sweep covers the flue, firebox, smoke shelf, and damper, plus a camera inspection and a written report. Liner replacement, crown repair, and cap installation are quoted separately if we find a problem. You will always know what is included before we start.
Chimney rods and a chimney brush clear soot and creosote from the full length of the flue. Glazed deposits get a wire brush and a creosote sweeping log treatment. Debris drops into a sealed bag, not your floor.
An inspection camera runs the length of the flue to check flue tiles, mortar joints, and the smoke chamber. You see the footage on our screen, and we flag anything that needs repair before it turns into a bigger problem.
We scrape and vacuum the firebox, smoke shelf, and damper with an ash vacuum and HEPA vacuum. Firebrick and mortar get checked for spalling, and we test the damper seal so you are not losing heat up the flue.
Up top we inspect the chimney cap, chimney crown, and flashing for cracks, rust, or loose mortar. A cracked crown lets water into the masonry, which is the number one cause of freeze-thaw damage in Lawrence chimneys.
You get a written summary of what we found, what we cleaned, and what needs attention. Photos are included. It is useful documentation if you are selling the house or filing an insurance claim after a chimney leak.
We lay drop cloths from the door to the hearth and seal the firebox opening. You get a quick walkthrough of what you have been noticing, how often you burn, and whether the flue has ever been relined. Two minutes of questions saves us from guessing later.
We run chimney rods and a chimney brush up from the firebox, then sweep from the top down when roof access is safe. Glazed creosote gets a wire brush and a creosote sweeping log treatment. Soot and debris drop into a sealed collection bag, not your living room.
An inspection camera goes the full length of the flue. We look for damaged flue liner tiles, cracked mortar, gaps at the thimble, and any obstruction. You see the footage on our screen, and we point out anything that needs attention before it gets worse.
We scrape and vacuum the firebox, smoke shelf, and damper with an ash vacuum and HEPA vacuum. Firebrick and mortar get checked for spalling. If the damper does not seal, we note it, because a leaking damper bleeds heat all winter.
Up top we check the chimney cap, crown, and flashing for cracks or rust. You get a written report with photos, plus a straight answer on what needs fixing now versus what can wait until spring. No pressure, no upsell script.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
The core sweep kit. Rods push a brush sized to your flue up from the firebox, or down from the roof, to break soot and creosote off the flue tiles.
A lighted camera on a reel that runs the full length of the flue. It shows cracked flue tiles, failed mortar joints, and blockages that you cannot see from the firebox.
HEPA filtration captures fine soot particles so they do not settle on your furniture. The ash vacuum handles the heavier firebox debris without clogging.
We lay drop cloths from the door to the hearth and seal the firebox opening before we start. It keeps soot out of the room and makes cleanup a five-minute job.
For glazed stage-two and stage-three creosote that a standard brush will not touch. The wire brush breaks the surface, and the sweeping log chemically dries the deposit so it can be removed.
Lets us remove and reseat the chimney cap without damaging the mesh or the mounting bolts, so we can inspect the flue from the top and check the crown at the same time.
The homeowner had not had the flue swept in four years. Stage-two creosote coated the upper flue tiles, the damper did not seal, and smoke smell lingered in the living room even when the fireplace was cold.
Two hours of sweeping and vacuuming cleared the flue, and the camera showed the flue tiles were still sound. The damper got adjusted, and the smoke smell was gone the next day. Total cost came in under $400.
A homeowner was burning nearly a cord more wood than the previous winter and the stove glass sooted up within a day of cleaning. The flue was restricted and the cap was partially blocked with debris.
We swept the flue, cleared the cap, and replaced a worn door gasket. The stove pulled air properly again, and the homeowner reported using noticeably less wood over the next month. Job took about 90 minutes.
Water stains had appeared on the ceiling near the chimney after a wet spring. The crown had a visible crack, flashing was loose, and mortar joints on the chimney exterior were spalling from repeated freeze-thaw.
We sealed the crown, reseated the flashing, and repointed the damaged joints. A follow-up after the next heavy rain showed no new water intrusion. The repair cost a fraction of a chimney rebuild.
Most chimney calls come down to five issues. Here is what they look like, what happens if you ignore them, and how we handle each one.
Ask a pro →We sweep the flue with chimney rods and a chimney brush, then treat glazed deposits with a wire brush and a creosote sweeping log. If the glaze is too far gone for a standard sweep, we tell you and quote a chemical treatment or reline.
We check the flue for animal nest blockages, test the damper, and measure the flue against the firebox opening. Most backdraft cases clear up after a proper sweep and a damper adjustment. If the chimney is undersized, we explain the fix.
Our inspection camera catches liner damage early. Small cracks get repointed. Larger failures get a stainless steel liner sized to the appliance, installed to NFPA 211. We quote it flat and show you the footage before you decide.
We seal the crown, repair flashing, and repoint mortar joints before the freeze sets in. If the chimney cap is rusted or missing, we replace it. Catching a leak in October saves you a masonry bill in March.
Most residential sweeps in Lawrence run $180 to $450 in 2026, and a sweep plus a multi point chimney inspection lands between $300 and $650. A basic flue cleaning on a straight, easily accessed chimney sits at the low end. Add a wood stove, a steep roof, heavy glazed creosote, or a commercial flue and the price climbs. We quote flat before we start.
Three things: certification, insurance, and equipment. A professional carries CSIA Certified Chimney Sweep credentials, follows NFPA 211, and uses an inspection camera plus HEPA vacuum on every job. Anyone can buy a chimney brush. The certification and the camera are what separate a real sweep from a guy with a ladder and a shop vac.
Yes. Our technicians hold CSIA Certified Chimney Sweep credentials, and we carry NFI Certified training for wood stoves and inserts. We also maintain an Indiana state license and OSHA safety certification. You are welcome to ask for the certification card at the door, and we will hand it over before we unpack a single tool.
Once a year if you burn regularly, and twice a year if you run a wood stove as primary heat. Lawrence sees enough freeze-thaw and damp spring weather that creosote hardens faster than in drier climates. If you can see 1/8 inch of buildup on the flue walls, or you smell smoke when the fireplace is cold, book a sweep.
Chimney sweep near meIf you searched chimney sweep near me, we cover Lawrence and the surrounding Marion County neighborhoods. Same crew, same camera inspection, same flat pricing whether you are in Deerfield or Old West Lawrence.Explore →
Emergency Chimney sweepSmoke rolling into the room, a chimney fire scare, or a nest blocking the flue gets priority. We keep emergency slots open and can often reach Lawrence homes the same day you call, especially during the fall burn season.Explore →
24/7 chimney sweepOur phone line stays open around the clock for urgent chimney problems. A technician talks you through shutting down the fire safely, then we schedule the earliest available slot. Not every call needs a midnight visit, and we will tell you which one yours is.Explore →
chimney cleaningStandard chimney cleaning removes soot, ash, and creosote from the flue, firebox, and smoke shelf. It is the core of what we do, and it is the service that prevents most chimney fires. Most homes take 60 to 90 minutes.Explore →
chimney cleaning near meSearching chimney cleaning near me in Lawrence brings up a lot of out-of-town outfits. We are local, we know these roofs, and we can usually get to you within a few days during the busy October and November stretch.Explore →
fireplace cleaningFireplace cleaning goes beyond the flue and covers the firebox, glass doors, grate, and hearth. We scrape firebrick, vacuum ash with an ash vacuum, and check the damper seal so your fireplace stops bleeding heat up the chimney.Explore →
chimney inspectionA chimney inspection uses an inspection camera to check flue tiles, mortar joints, the crown, and the cap. It is the fastest way to catch a damaged flue liner before it becomes a rebuild. We do level-one, level-two, and level-three inspections.Explore →
chimney inspection near meIf you need a chimney inspection near me in Lawrence, we cover the whole city plus Marion County. Every inspection includes photos and a written summary, so you have documentation for insurance or a home sale.Explore →Fall slots fill fast, and a dirty flue is not something to gamble on. Call (855) 959-5820 and we will get you on the schedule, usually within a few days. Flat pricing, CSIA Certified Chimney Sweep technicians, and a camera inspection on every visit.
Schedule My Sweep (855) 959-5820 →Call (855) 959-5820 or email [email protected] and we will get back to you the same business day. Our phones are answered Monday through Friday, 8 a.m. to 6 p.m., and the emergency line stays open 24/7 for chimney problems in Lawrence. Same-day slots are often available if you call before noon.